Harvester Method Of Operation

The operating method of the Harvester

The Harvester was invented by Cyrus McCormick. The Harvester is the machinery of the integrated harvesting of crops. Once the harvest, threshing, and the grain will be concentrated in the storage warehouse, and then through the conveyor belt to the transport of food to the truck. Can also be used for artificial harvesting, rice, wheat and other crops laid in the field of straw, and then use grain harvesting machinery to pick up threshing. Harvesting rice, wheat and other cereal crops and straws crop harvesting machinery. Including Harvester, cutting machines, balers, grain combine Harvester and grain threshers. Grain harvesting machinery is developed on a variety of harvesting and thawing tools.

Method of operation

The Harvester is a mechanized harvesting crop that finishes harvesting, threshing, and concentrating the grain into the storage bin, and then transport the grain to the truck through the conveyor belt. Can also be used for artificial harvesting, rice, wheat and other crops laid in the field of straw, and then use grain harvesting machinery to pick up threshing. Harvesting rice, wheat and other cereal crops and straws crop harvesting machinery. Including Harvester, cutting machines, balers, grain combine Harvester and grain threshers. Care should be taken when handling Harvester:

1, before the harvest before: check the Harvester parts are intact.

2, the machine into the field, and then pull the straw pull to the job location, put down the grain table, the grain exclusion gate pulled to "open" position, then the food bag hook hanging on the food bag, the machine fired ridge vertical position.

3, the commissioning machine: dust control handle to the "standard" position, vice variable handle according to crop conditions, select the pull to the "high speed" or "low speed" position, row of grass handle into the "grass" or "grass "position.

4, down the cutting table, so that the front of the Wo Wo device down to the surface of 5-10cm away from the field.

5, will be out of the clutch and cut off the clutch handle to the joint position.

6, the main variable speed handle slowly push forward, so that the machine began to harvest.

7, when the crop began to enter the threshing mouth, the operation of the threshing depth manually adjust the switch, so that the spike from the depth of the location of signs.

8, the crop after all harvest, will cut the clutch handle to the separation of the position.

9, until the food is no longer out of grain, the threshing clutch clutch handle to the separation position.

10, check the machine parts switch is closed.

11, to reduce the throttle, the engine flameout.

12, the Harvester back to the placement point and a certain inspection and maintenance.