Harvester Operation Precautions

The harvesters are integrated mechanics for harvesting crops, invented by Cyrus McCormick. The harvester finishes harvesting, threshing, and concentrating the grain into the storage bin, and then transport the grain to the truck through the conveyor. Can also be used for artificial harvesting, rice, wheat and other crops of the straw laying in the field, and then use grain harvesting machinery to pick up threshing.

Mainly divided into side hanging, backpack, hand-held, horizontal, vertical harvester. The development trend is to use new materials to further reduce the weight; the use of low vibration engine and advanced vibration isolation device and reasonable configuration of parts to reduce the vibration of the human body hazards.

Harvesting rice, wheat and other cereal crops and straws crop harvesting machinery. Including harvesters, cutting machines, balers, grain combine harvesters and grain threshers. When operating the harvester should pay attention to:

1, before the harvest before: check the harvester parts are intact.

2, the machine into the field, and then pull the straw bar to the job location, put down the grain table, the grain exclusion gate pulled to "open" position, then the food bag hook hanging on the food bag, the machine fired ridge vertical position.

3, commissioning machine: dust control handle to the "standard" position, vice variable handle according to the crop conditions, select the pull to the "high speed" or "low speed" position, row of grass handle into the "grass" or "grass "position.

4, down the cutting table, so that the front of the Wo Wo device down to the surface of 5-10cm from the field.

5, will be out of the clutch and cut off the clutch handle to the joint position.

6, the main variable speed handle slowly push forward, so that the machine began to harvest.

7, when the crop began to enter the threshing mouth, the operation of the threshing depth manually adjust the switch, so that the spike from the depth of the location of signs.

8, the crop after all harvest, will cut the clutch handle to the separation of the position.

9, until the food is no longer out of grain, the thresher clutch handle to the separation position.

10, check the machine parts switch is closed.

11, reduce the throttle, the engine flameout.

12, the harvester back to the placement point and a certain inspection and maintenance.